Extended Settings and Functions
21
6.1.3.5
Delete All
Select the menu item
Delete All
to delete all previously set satellite positions. This menu
item is only active, if you selected the motor control
DiSEqC1.2
6.1.3.6
Motor Setting
Select
Motor Setting
and press
OK
to open the submenu
Motor Setting
1. Select
Satellite
to select the satellite to which the following settings should apply.
2. Select
Transponder
to select the transponder that should be decisive for the antenna position
(usually the transponder that is used to send your preferred channel).
3. Select
Pos No. & Save
to determine a position number at which the respective satellite (i.e. the
respective antenna position) should be saved.
4. Select
Go to X
to call a position from which you want to make the selection (the value
Reference
is the zero position).
5. Select
Save
and turn the antenna to the west or east by using the keys
and
. Search
for maximum values of signal strength and signal quality (are displayed at the lower screen edge).
6. Then press
OK
to save the found position. A query will be displayed.
7. Confirm change of position by pressing
Yes
or discard such change by pressing
No
.
8. Repeat the steps 1 to 6 for any further satellites/transponders, if applicable.
Select
Recalculation
and press
OK
to discard any previous settings and to again determine
antenna position.
Press
EXIT
to return to the submenu
Antenna Setup
.
6.1.3.7
Antennen Limit
Select Limit setup and press
OK
to open the window Limit setup.
1. Select
Limit setup
to switch between
Disable Limit
,
West Limit
and
East Limit
.
2. Mark the button
Limit setup
and move the limit - as defined in the previous step - to the east or
west by using the keys
V+ / V-
.
3. Mark the button
Go to Reference
and then press
OK
to move the motor antenna to its starting
position.
4. Press
EXIT
to return to the submenu
Antenna Setup
.
6.1.4
Single Satellite Search
Here you can scan individual satellites for receivable channels.
At
Satellite
, select the satellite for which the scan should be performed.
Also here, options are limited to the satellites that are marked in the
Satellite
List
as such satellites from which you want to receive channels.
Select
FTA Only
6
to determine if scan should be made only for FTA channels or for all
channels.
At
Scan Channel
, select if you want to perform scan only for TV channels, only for radio
channels or for TV + radio channels.
6
FTA =
F
ree
T
o
A
ir = unencrypted channels
