Smart Sensor Model AS850, Инструкция по эксплуатации

Страница: 10 / 10

-07- -08-
3.3 Thickness measurement
Put the coupling agent on the area to be measured to couple the trans-
ducer with the hardware/workpiece, LCD will display the thickness
reading.
Notes: icon on the screen indicates a well coupling, if the icon fla-
shes or not shows that means a poor coupling. After remove the trans-
ducer, the reading will be hold.
In a well coupling measurement Measurement accomplished
3.4 Sound velocity measurement
With a given thickness to read out sound velocity of material: Obtains
the thickness of material by using vernier caliper / micrometer, then
couple the transducer with that sample material until a reading displays
on the LCD, remove the transducer and press or to adjust the
reading match the thickness by caliper/mirometer, then press VEL to
display the sound velocity and save in current velocity memory unit.
Measuring the thickness Adjusting actual thickness Velocity read out
(1) Keep pressing STORE for 2 seconds to enter save thickness data mode,
LCD display THICKNESS, mm, icon with first memory unit. If the first
memory unit is not being registered, so LCD will display 0.0.
(2) Press or to select your desired memory unit (1-10).
(3) After picked up the memory unit, it will begin to work. While measuring,
the memory unit NO will flash and the new measurement will be renew
the memory unit, when the measurement completed, the last reading will
be stored in the selected memory unit automatically with the memory unit
NO stop blinking. “ ”
3.6 Review the saved data
Press
the memory unit NO and stored data displayed. You can
review the saved data in 1-10 units by pressing “ ” and “ ” and they
are read-only. Press “STORE” will back to measurement mode.
“CAL”,
Select memory unit
Taking measurement &
saving data
Measurement & storage
accomplished
3.5 Data storage
Review saved data