Smart Living Steam Mop Plus, Инструкция по эксплуатации

Страница: 9 / 16

IMPORTANT
Your steam mop needs water to make steam! Never use your steam mop without water
in the tank or a pad attached. Sweep or vacuum your floors before using your steam mop.
It may take a few seconds for the mop to warm up and start steaming after you plug it
in. If you press the steam button and the unit does not begin to steam immediately, just
wait a few seconds for the mop to heat up to a deep cleaning and sanitizing temperature
1. Pull and twist the quick release cord holder to unwrap the power cord completely.
(fig.1)
2. Plug into a standard electrical outlet. (fig.2)The LED light will blink blue to show
that you are in standby mode. If the light does not turn on, reference the trouble
shooting section.
3. Press the steam button, the LED light will turn solid blue, and the electronic pump
will automatically generate steam.(fig. 3)
4. Clean your floors with a forward and backward motion. (fig.4)
5. Press the steam button at any time to stop the steam.
fig. 1
fig. 2
fig. 3
fig. 4
Operation
When you use your steam mop for the first time or if you have not used the unit in a
while, it may take a minute or two for the water to travel through the pump and into the
heater to create steam. If you have waited a few minutes and you still do not see any
steam, reference the troubleshooting section.
7