SMART Embedded Computing Centellis 2x00 User Card-10GE, Инструкция по установке и эксплуатации

Страница: 37 / 50

Centellis 2x00 User Card-10GE Installation and Use (6806800H33E) 37
Chapter 3
Controls, Indicators and Connectors
3.1 Face Plate
The following figure highlights the position of LEDs and connectors on the face plate of the
board. The LEDs and connectors are described in the following sections.
3.1.1 LEDs
The following LEDs can be found on the face plate of the board. OOS, OK and H/S are
ATCA LEDs and can be controlled via IPMI. For more information, see the Centellis 2x00
User Card-10GE: Control via IPMI Programmer’s Reference manual.
3.1.2 Ethernet Connectors
A SFP+ port located on the front panel allows for Ethernet connectivity from the payload to
an external device.
Figure 3-1 Face Plate
Table 3-1 Face Plate LEDs
LED Color Description
OOS (failure) Red
Red: The Centellis 2x00 User Card-10GE is out-of-service.
Off: The Centellis 2x00 User Card-10GE is working
properly.
OK (power) Green
Green: The Centellis 2x00 User Card-10GE is operating
properly.
Off: Otherwise
Blinking: The board boots up.
H/S Blue
Blue: The Centellis 2x00 User Card-10GE is ready to be
extracted.
Off: The Centellis 2x00 User Card-10GE is not ready to be
extracted. Do not remove the board during this state.