SMART Embedded Computing Centellis 2x00 User Card-10GE, Инструкция по установке и эксплуатации

Страница: 32 / 50

32 Centellis 2x00 User Card-10GE Installation and Use (6806800H33E)
Centellis 2x00 User Card-10GE Hardware
Centellis 2x00 User Card-10GE Hardware
2.5 Installing and Removing SFP/ SFP+ Modules
This section describes how to install and remove SFP and SFP+ modules.
2.5.1 Installing an SFP/SFP+ Module
Procedure
In order to install an SFP/SFP+ module, proceed as follows:
Eye Damage
Optical SFP/SFP+ modules may emit laser radiation when no cable is connected.
Avoid staring into open apertures to avoid damage to your eyes.
Personal Injury and Damage of the RTM and SFP/SFP+ Modules
Installing and using SFP/SFP+ modules which are not fully certified and which do
not meet all relevant safety standards may damage the RTM and the SFP/SFP+
modules and may lead to personal injury.
Only use and install SFP/SFP+ modules which are fully certified and which meet all
relevant safety standards.
Personal Injury
Optical SFP/SFP+ modules may be classified as laser products. When installing and
using any of these SFP/SFP+ modules, the regulations which correspond to the
respective laser class apply to the whole RTM. Not complying to these regulations,
may lead to personal injury.
When installing and using optical SFP/SFP+ modules which are classified as laser
products, make sure to comply to the respective regulations.
SFP/SFP+ modules can be installed/removed both while the RTM is powered and
non-powered. The presence and also the type of SFP/SFP+ modules is automatically
detected.
The maximum power consumption of all installed SFP/SFP+ modules must not
exceed 12 W.