TT400 WirelessHART
®
- Operation, Maintenance anda Instructions Manual
3.4
a) First, make mounting the antenna on the
side of the housing indicated by "FIELD
TERMINALS." Always keep the antenna
upright.
b) Tighten the antenna with a wrench. Use the
wrench to how the picture is being
displayed, always below the antenna;
c) Screw radio board on the back of the
housing. Pass the antenna cable to the
mark indicated in the picture and connect it
to the radio board as shown in the picture;
d) Screw Batteries Module and connect it to
the radio board at the point indicated;
e) Connect the sensor from the bottom, as
shown in the picture, threading it carefully;
f) Place the main board on the front of the
housing and connect the sensor cables and
radio to it. After connection, screw the
board to the housing;
g) Finish putting the front and back covers.
Table 3.3 – Quick Assembly Procedure Transmitter
Considering the complete assembly of the device must be initiated by the antenna set.
To mount the antenna set (
20
) simply screwing it on the side of the equipment with the aid of a wrench,
as shown in Figure 3.2. To mount the radio board (
13
) first connect it to the main board (
6
) and then
attach to the housing through its screws (
14
). Connect the antenna cable to the connector on the radio
(Figure 3.2). To assemble the battery module (
16
) simply screwing it to the housing, using its screw
(
17
). To assemble the input board (
24
) first connect it to the main board (
6
) and then attach to the
housing through its screws (
25
) and spacers (
23
). The sensor must be done with the use of the cable
gland (to ensure sealing) in the housing (
26
) and ends with the closing of the thread sensor (
27
).
To mount the main board (
6
) make sure that the cables to the radio board (
13
) and input board (
24
) are
connected. Secure the board to the housing through its screws (
5
) and be sure to leave the terminal
ON/OFF (Figure 1.4) in the off position (OFF). To fix the display (
4
) on the main board (
6
) just mount it
in the correct position (up arrow) using the four screws (
3
). To finish the equipment assembling, screw
the display (
1
) and rear (
18
) covers clockwise.
Содержание TT400WH
