SMAR TT400WH, Руководство пользователя

Страница: 13 / 46

Installation Flowchart
XIII
Installation Flowchart
Was the transmitter
configured on the bench
to match the application?
Configure the sensor type
(Section 3).
Configure sensor connection
(Section 3).
Configure the engineering unit
(Section 3).
Configure the range measurement
0% and 100%
(Section 3).
Start
No
Yes
Check if the cable glands and electric
terminals are in good conditions and
properly held. Also check if the cover
and plug are air-tight sealed.
Iinstall the transmitter preferably
on weather - protected areas.
Install the transmitter, according
to the application after checking
the best position for LCD and if the
antenna position is pointed up
(Section 4).
Check the area classification and
if the transmitter can be energized.
OK
Configure the damping
(Section 3).
Configure the alarm
(Section 3).
Configure the reading in the LCD
(Section 3).
Simule the mV or Ohm value(s)
of the work range in the sensor(s)
connection terminal(s).
Is the reading
correct?
Consult the manual (Section 4)
- Maintenance.
No
Yes
Configure Network ID and Join Key
for Wireless HART
TM