BATCAM 2.0
31
Product Certification
I.
Electromagnetic Compatibility
This product meets the requirements of the following EMC standards for measurement, control and sensitive
electronic equipment used in laboratories. EN 55032:2015/AC:2016
✓
EN 55035:2017
✓
EN 61000-3-2:2014
✓
EN 61000-3-3:2013
II.
FCC Compliance
This product meets the essential requirements of the applicable U.S. Directive as follows:
✓
FCC Part 15 Subpart B, Class A
III.
CE Compliance
This product meets the essential requirements of the applicable European Directive as follows:
✓
2004/108/EC; Electromagnetic Compatibility Directive(EMC)
IV.
KC Compliance
This product proves that it has been registered in accordance with paragraph 2-3 of Article 58 of the Radio
Wave Act.(The Clause 3, Article 58-2 of Radio Waves Art.)
V.
Battery
This product uses lithium ion batteries.
Do not use the product in environments where it can be wet, wet, or corroded. Do not store or place the
product in or near the source of heat in a high temperature, strong direct sunlight, microwave or pressurized
container. Also, do not expose to temperat
ures above 122 °F / 50 °C. Failure to follow these instructions may
result in acid leak, heat, explosion or ignition, causing injury and damage. Do not drill, open or disassemble
the battery. If the battery is in contact with the leaked fluid, rinse it with water sufficiently and seek a
www.
GlobalTestSupply
.com
Find Quality Products Online at:
