Slugger Metal Cutter MCSL07, Руководство оператора

Страница: 12 / 16

1. After the cut, release trigger switch to “OFF” position. Wait until saw motor completely stops.
2. Place saw on secure and level surface.
AFTER THE CUT
12
WARNING!
NEVER START SAW MOTOR WITH CUTTING EDGE OF SAW BLADE CONTACTING WORK SURFACE
.
DO NOT RETRACT BLADE GUARD
(
ITEM
# 15)
MANUALLY
.
GUARD RETRACTS AUTOMATICALLY
.
7. Position saw base plate on work surface near desired cutting area.
8. Depress and hold trigger switch lockout mechanism (item# 46).
9. When ready, start saw motor by activating trigger switch (item# 46).
10. Slowly approach material edge and gently apply pressure until saw blade has established a cutting groove in the material.
11. During remainder of cut apply smooth, constant pressure without overloading saw motor.
WARNING!
THIS MACHINE
’
S CIRCUITRY WILL AUTOMATICALLY SHUT THE SAW MOTOR OFF IF EXCESSIVE OVERLOAD IS MAINTAINED
.
IF SAW MOTOR SHOULD STALL OR STOP BEFORE A COMPLETE CUT IS MADE ALWAYS REMOVE BLADE FROM MATERIAL
BEFORE ATTEMPTING TO RESTART MOTOR
.
FAILURE TO DO SO COULD RESULT IN PERSONAL INJURY
.
1. The surface you are working on should be clean and level, free from rust, scale, dirt and chips.
2. Adjust the base plate to the desired bevel angle by loosening and then re-tightening the T-knob (item# 57).
3. For long, straight cuts in sheet stock, position the edge guide to the desired width and secure with thumb screw.
4. Adjust base plate for proper cutting depth. Secure using depth adjustment knob (item# 59).
5. Connect machine to power source.
6. Firmly grasp guide handle and trigger handle switch (item# 46).
OPERATION