2A - INSTALL EBF-625 FAUCET
NoTE: Sloan Valve Company reccomends that this faucet is installed
with our trim plate. our trim plate includes an anti-rotation feature to
prevent rotary motion of this single-hole pedestal-style faucet.
Slide faucet base gasket over faucet shank and sensor cable.
install optional trim plate next followed by the trim plate gasket. holding
the faucet base gasket and optional trim plate assembly in place, insert
sensor cable and faucet shank through the 1” (25 mm) center hole in
deck lavatory. use plumber’s putty to secure optional trim plate.
Thread sensor cable through side of mounting spacer, and then secure
faucet to deck or lavatory using the mounting washer, lock washer and
nut. apply thread sealant or Teflon tape to threads at end of faucet
shank.
2B - INSTALL EBF-655 FAUCET
NoTE: refer to the installation instructions included
with the ETF-578-a trim plate for addtional information
about using an 8” trim plate with an EBF-655 faucet.
Slide faucet base gasket onto faucet.
insert faucet sensor cable, pipe nipple, and mounting studs through the
4” (102 mm) spread deck holes. Secure faucet to deck using slotted
mounting washers and wing nuts supplied.
3 - MOUNT CONTROL MODULE TO WALL
imporTaNT: Do NoT install control module upside down. The
control module may be oriented so that it faces sideways (vertically);
however, optimum performance is obtained when the control module is
horizontal with the Sloan logo on the cover facing up.
install the control module in an appropriate location. all four (4) cover
screws must be accessible from the chosen mounting position. after
installation, the cable from spout to control module should have
some slack.
remove control module cover from control module base. use the control
module base as a template to mark locations on wall for mounting
fasteners. Determine the appropriate mounting fastener for the particular
wall type (three different fastener types are included; see parts list). Drill
four (4) appropriately sized holes.
For plastic wall anchor – 1/4” (6 mm) holes
For hollow wall anchor – 5/16” (8 mm) holes
For toggle nut anchor – 3/8” (10 mm) holes
install 3/8” compression fitting on end of faucet shank.
FAUCET
BASE GASKET
FAUCET SENSOR
CABLE
1/4" NPT PIPE
NIPPLE
1/4" NPT PIPE TO 3/8"
TUBE COMPRESSION
FITTING
MOUNTING
SPACER
FLAT WASHER
LOCKWASHER
MOUNTING NUT
FAUCET
SLOTTED MOUNTING
WASHERS (2)
WING NUTS (2)
MOUNTING STUDS
FAUCET SENSOR
CABLE
1/8" NPT PIPE
NIPPLE
BASE GASKET
A
B
C
D
A
B
A
B
C
attach Control module base to wall using appropriate fastener.
DRILL FOUR HOLES INTO WALL
USING MOUNTING FASTENERS
APPROPRIATE FOR THE
PARTICULAR WALL TYPE:
• PLASTIC WALL ANCHOR —
1/4" (6 mm) HOLE
• HOLLOW WALL ANCHOR —
5/16" (8 mm) HOLE
• TOGGLE NUT ANCHOR —
3/8" (10 mm) HOLE
CONTROL
MODULE
WALL
PLASTIC ANCHOR
WITH SCREW AND
WASHER SHOWN
3-1/2"
(89 mm)
4-3/8"
(111 mm)
