ML-30CR
11
12
6. Settings
C12V power supply through the gray (+) and black (–) wires of the
door panel communication cable.
6.1. Memory reset
Press and hold «reset» button (situated under resin cap on the back cover of
the door panel, see page 6) for 3 seconds, until long beep sound is heard.
Release «reset» button and shortly press it again for three times. Then you will
hear 3x long beep sound. It means that the memory was reseted.
6.2. Master password setup
1) In standby mode enter master password (default master password is
1234) and press # button to enter settings mode. Double long beep
sound will be heard;
2) Press 0 and # button to enter into master password setup mode. One
long beep sound will be heard;
3) Enter new 4-digit password and press # button. One long beep sound
will be heard;
4) Press * button to exit into standby mode. Double short beep sound will
be heard.
Surface mounting:
1) Take a surface mounting bracket from the kit and place it 150-160 cm from
the floor line;
2) Mark and drill two halls inside the wall;
3) Take two nuts from the kit and hammer them into the drilled halls;
4) Fix the surface mounting bracket on the on the wall with two screws from
the kit;
5) Connect all communication wires and fix the door panel on the surface
mounting bracket with the screw from the down side.
