Sleipner SEP-IP60, Руководство по установке, Страница: 4 / 28

4
4354 11 2021
-
SEP IP 60
MC_0057
Technical Specifi cations
EN
Motor: Custom made reversible DC-motor.
Gear house: Seawater resistant bronze. Ball-bearing at propeller shaft and a combination of ball bearing and slide bearing at drive shaft.
(Pre-fi lled and sealed for life)
Motor bracket: Glass fi bre reinforced composite material. Brass thread inserts.
Ignition
Protection: Conforms to ISO 8846
Tunnel: Cross spun with rowing G.R.P tunnel
Steel & aluminium tunnels available at request.
Propeller: 5-blade skewback “Q-prop” propeller, fi breglass reinforced composite.
Batteries: Minimum recommended battery capacity (cold crank capacity by DIN/SAE standard)
Contact a battery supplier for more information.
Max. Use: 2 - 3 min. duty cycle at 20º
Safety features: - Electronic time-lapse device protects against sudden change of drive direction.
- The electric thermal cut-off switch in electro motor protects against overheating (auto-reset when electro motor cools down).
- Flexible coupling between electro-motor and drive shaft protects electro motor and gear system if propeller jams.
- Original Sleipner panels shut off automatically 6 minutes after last use.
- Original Sleipner panels use child-safe double ON buttons.
- An integrated microprocessor monitors solenoids, reduce wear and risk of solenoid lock-in.
- Auto-stop of the thruster occurs when an undesirable solenoid lock-in occurs or when continuous operation cut-off timer
exceeds 3 minutes.
MC_0130
Thruster Measurements
EN
Measurement
code
Measurement description
mm inch mm inch
ID Internal tunnel diameter 185 7,28 185 7,28
H Motor Height 321 12,64 321 12,64
W Width 232 9,13 232 9,13
L Length 272 10,71 272 10,71
WD Water Depth 185 7,28 185 7,28
TL Minimum tunnel length 128 5,04 128 5,04
TL (recommended) Recommended tunnel length 165 6,50 165 6,50
T (min) Minimum tunnel wall thickness 4 0,16 4 0,16
T (max) Maximum tunnel wall thickness 6 0,24 6 0,24
* IP 60
12v
* IP 60
24v
*Valid for SE IP & SEP IP
MG_0311
H
W
L
TL
WD
ID
T
Tunnel centre line
Single Propeller
The gear leg/ propeller(s) must
never extend out of the tunnel
Propeller position will
vary with each thruster
model