SLE 800 Series, Руководство по эксплуатации

Страница: 14 / 43

It is not possible to recommend a given temperature for any particular substrate to be imprinted
because of the various production conditions that are encountered. The affecting factors are:
•
Formulation of the foil
•
Surface to be imprinted; coarse or smooth
•
Pressure applied
•
Dwell time
•
Type style used; light face vs. bold face
•
Ambient condition
The following table is a guide in determining the proper setting, based upon the type of material
being imprinted. These readings, however, are only approximates and may require minor adjustments
to achieve the optimal result. To ensure a good imprint, it is recommended that you set the
temperature slightly lower in the beginning, and increase as necessary.
TEMPERATURE TABLE
Regulator Knob Setting
1-3 3-5 5-7
Temperature (
°
F) 190-230
(88
°
C-110
°
C)
230-260
(110
°
C-127
°
C)
260-280
(127
°
C-138
°
C)
Applicable Substrates
(for reference only) Mylar, leather, PVC Ribbon, paper Plastic, wood
1. Plug in your SLE Hot Printer and turn on the power. (The Green and Red lights come on.)
2. Turn the Regulator Knob to the appropriate scale according to the above table. When the
temperature has reached the set point the green light on the temperature control panel will
begin to flash, on and off.
3. When the flashing begins, wait another minute or two for the heat to reach the typeface, then
proceed to make a test print.
Preparing the Type, Emblem, or Die
Power-on
Regulator