4.
INSTALLING YOUR NINJALINE™
DIAGRAM OF A NINJALINE™ SETUP
2,5m Tension section
Obstacle course line section with 13 Clip openings
Looped End section
1
2
3
4
5
6
7
8
9 10 11 12
Ratchet
Tree with ratchet line
Tree with NINJALINE™ End
wrapped around.
wrapped around
NOTE: YOUR RATCHET WILL ONLY TAKE UP ABOUT 30cm of line! -READ INSTRUCTIONS CAREFULLY!
TO PROTECT YOUR TREES BARK FROM
POSSIBLE DAMAGE-Tree Huggerz is
available (Sold separately)
Step 1:
Determine your course height.
WARNING: LINE HEIGHT SHOULD BE SET TO WHERE YOUR SHORTEST (HEIGHT) NINJALINE™ USER’S FEET
ARE ONLY 30cm MAXIMUM FROM THE GROUND AS THEY HANG FROM THE LOWEST NINJALINE OBSTACLE.
•
As a starting height to set you line at, have the shortest (height) user reach up above their head as
high as they can, measure that height (from the ground to the tips of their outstretched hands) and
then add an additional 60cm which is 30cm for clearance plus 30cm for the NINJALINE™ sagging
towards the ground with the user’s weight. For example, your shortest Ninja is 1.80m (from the
ground to their outstretched finger tips), add 60cm, and your first line height to test should be 2.40m
from theground.
•
This may take one or two adjustments to get the desired 30cm of clearance for the Ninja above the
ground.
Step 2:
Wrap the ratchet and its line around your smaller diameter of the two treesyou have selected for your course.
Thread the ratchet through the looped end. TIP: to keep you line flat, pinch the line to form a U-shape section where it
feeds through the looped end. ( See Figure 1) Pull the ratchet so the line is snug. ( See Figure 2).
Step 3:
Take NINJALINE™ course line and using a stable step ladder, wrap around the other tree and tighten keeping
line flat and not twisted. Pull the course line through (Figure 3).
FIGURE 1
FIGURE 2
FIGURE 3
