22
Installation of the Unit
CAUTION!
Always check that the drain cap is installed to the unused
drain port and is fastened with the nylon fastener. If the
drain cap is not installed, or is not sufficiently fastened by
the nylon fastener, water may drip during the cooling
operation.
Fig.31
Fig.32
Fig.33
Drain port
Drain cap
Fastener
(8). When using the drain port on the right side of the unit,
reinstall the drain cap to the left side drain port.(Fig.31)
(9). Be sure to insulate where the drain port and the drain hose is connected.(Fig.32 )
(10). The unused drain port also should be insulated properly.(Fig.33)
(11). There is adhesive on one side of the insulation so that after removing the protective
paper over it the insulation can be directly attached to the drain hose.
2. Testing of Drain Piping
After piping work is finished, check if drainage flows
smoothly.
As shown in the figure, add approximately 1 liter of
water slowly into the drain pan and check drainage
flow during COOL running.
Fig.34
Содержание SDVH12M-A1NBI/P
Страница 2: ......
