Skyworks SKY66430-11, Руководство пользователя

Страница: 6 / 15

SKY66430-11 / SQN66430-11 SiP • Evaluation Board User Manual V1.2
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
6 September 2, 2020 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • 205375C
4.0 Using the Evaluation Board
4.1 AT Commands

The evaluation board configuration and usage is all being done through AT commands

In order to send AT commands to the board, you need to use a Serial Terminal program under Windows (e.g., Tera Term freeware)

To send an AT command to the board, you need to connect your Serial Terminal to the "UART 0" port, corresponding to COMa on
Windows enumeration. Please refer to the table in Overview of the COM Ports on page 5 to determine the exact COM port on your PC

Configure the correct Baud rate 115200 and the other settings in the terminal
Figure 7. Tera Term Serial Port Setup

Once the correct setting is done, you should be able to start sending AT commands and receiving their corresponding output

You can start with ATE1 to enable the echo for the current session
Figure 8. AT Command Window
Note: You can access the latest version of the AT Command Reference Manual through the same channel where you obtained this
document. This reference manual describes the complete list of AT commands supported by SKY66430 SiP firmware.