SkyWave IDP 700 Series, Руководство по оборудованию

Страница: 37 / 70

IDP 700 Terminal Series - Hardware Guide
© SkyWave Proprietary 25 T206, Version 01

Fasten the terminal securely so that it is not loose and does not move easily.

Mount the terminal on a rigid, stable surface. If necessary, use a mounting bracket
(not supplied) or other suitable support.

Mount the terminal on a surface that does not get hotter than the maximum operating
temperature. If the surface may get hotter, mount the terminal with a thermal barrier
between it and the mounting surface.

Do not mount the terminal close to other electrical equipment due to possible radiated
and/or conducted electromagnetic interference.

Do not mount the terminal where water may build-up or collect. The terminal is not
waterproof. Choose a location where water moves away from the terminal.

Check that the terminal's cable reaches the power source before you drill any
mounting holes.

Do not mount the terminal close to radar or other communications antennas. Use the
following guidelines:
> 1 m from VHF/UHF antenna
> 3 m from loop antenna
> 4 m from MF/HF antenna
> 5 m from other satellite antennas
Not within a radar beam
Once you have picked the mounting location, mount the terminal (refer to Section 4.5).
4.4.1 Remote Standard Antenna Mounting Guidelines
CAUTION Mount the remote
antenna at least 20 cm
away from humans.
CAUTION Cable management and connector strain relief must be
incorporated in the installation. Secure the cable no more than
15 cm from the antenna enclosure and at regular intervals along
its length as part of the installation to prevent cable wear and
eliminate strain on the connector. Damage to the connector
interface or cable may otherwise result and lead to hardware
failure.

Do not drill any holes before checking that you have room for the bend radius of
the antenna cable. For reliable operation, do not go below a bend radius of
1.3 cm. Measure the bend radius of the cable as shown in Figure 18.