15
zipper clip
pothook
the first net hole
the first V- ring
Left of
Enclosure Door
5
A
A
B
B
6
5,
Note:This step requires two persons
.
Flip leg sections over so that the spring holes are now facing the sky
instead of the ground.
6
, Lay the Jump mat on the ground with the warning labels facing upwards.
Put the Enclosure Net on the Jump mat.
Make sure the first net hole on the left of enclosure door and
the V- ring with the zipper pull clip on the mat are aligned, insert the V-ring
with
the zipper pull clip into the first net hole
to the left of the enclosure
door
(please refer to drawing in page10).
Continue this process
in a clockwise direction around the jumping mat
to attach other V-rings to the “buttonhole” incisions on the bottom edge
of the net one by one.
Make certain that each of the V-rings on the trampoline mat is
threaded through the corresponding “buttonhole’ in the
Enclosure Net.
Stand two leg sections and hold them in the position as
shown. Slide the large end of one of the remaining Top
Tubes onto the small end of the indicated Top Tube
on one of the leg sections. Insert the small end of the Top
Tube into the indicated Top Tube with Socket on the
other leg section. Repeat this step until all four leg sections
are connected. When this step is completed, the frame
will be fully assembled and freestanding.
small end
Large end
