15
6
, Lay the Jump mat on the ground Put the Enclosure Net on the Jump
Mat, make sure the first net hole on the left of enclosure door and
the V- ring with the zipper pull clip on the mat are aligned, insert the V-ring
with
the zipper pull clip into the first net hole
to the left of the enclosure
door
(please refer to drawing in page10).
Continue this process
in a clockwise direction around the jumping mat
to attach other V-rings to the “buttonhole” incisions on the bottom edge
of the net one by one.
Make certain that each of the V-rings on the trampoline mat is
threaded through the corresponding “buttonhole’ in the
Enclosure Net.
*NOTE* Before beginning to attach the springs, make sure the
enclosure door is centered over a T-Joint. Follow instructions for
attaching springs below by beginning with the first spring attaching
the jumping mat V-ring directly to the left of the enclosure door to the
the frame spring hole directly to the left of a T-Joint.
Attach the Springs (8) as follows: Hook one end of a
Spring (8) into a V-ring. (See the inset drawing.) Hook
the Spring Tool(11)(not shown) to the free end of the first
Spring (8). Use the Spring Tool(11) to pull the first Spring
until it reaches the frame. Push the end of the first Spring
into a hole in the frame. Unhook the Spring Tool
After you have hooked one Spring (8) into one of the V-
rings on the Bed (Mat) (5), count exactly 24 V-rings and
24 frame holes in a clockwise direction. Attach a second
Spring to the V-ring and frame at this point. Count 24 V-
rings and 24 frame holes in a clockwise direction and
attach a third Spring. Count 24 V-rings and 24 frame
holes in a clockwise direction and attach a fourth Spring.
7.
After attaching the first four Springs (8), count exact-
ly 12 V-rings and 12 frame holes in a clockwise direction.
Attach another Spring to the V-ring and frame at this
point. Count 24 V-rings and 24 frame holes in a clock-
wise direction and attach another Spring. Count 24 V-
rings and 24 frame holes in a clockwise direction and
attach another Spring. You will now have 8 evenly
spaced Springs (8) attaching the Bed (Mat) (5) to the
trampoline frame.
Attach eight Springs (not shown) evenly between the
eight attached Springs in the same manner as before.
Attach sixteen Springs (not shown) evenly between the
sixteen attached Springs.
Continue to attach the remaining Springs between the
previously attached Springs, until all Springs are
attached.
Safety Note: For the Bed (Mat) (5) to have the even ten-
sion necessary for safety in jumping, the Springs (8)
must be attached as described. As you attach Springs,
carefully count the V-rings and frame holes. If a V-ring or
hole is skipped, reattach the Springs in the proper posi-
tion.
8
6
V-ring
Frame
7.
6.
Slit
6
Inset drawing
4
Skywalker
Skywalker
Printing
( Door of the Enclosure)
V-rings
16’direction
14’direction
2
2
Warning label
The first hole
The fourth hole
The fifth hole
Notice:The warning labels lies
midway on the fourth hole and the
fifth hole
