14
3.
Lay two Top Tubes(2) on the ground in the position as shown
Make sure the Top Tube is turned so the small holes (spring holes)
are facing the ground
Insert one Top Tube (2) into the Socket(12) as shown(a), insert the other Top Tube
(2) into the T-joint(13) as shown(b), secure them with M8X55mm Carriage Bolt(17)
and M8 Locknut(18).
Then insert one end of Top Tube with T-joint into the Socket of other Top Tube
3.
Repeat above assembly step until two assembly units(C) will be completed
Notice:do not tighten the locknuts
4.
4
C
a
b
Slide two Legs (4) into a Brace (3) as shown. The peak of
the Brace (3) should point toward the ground. Screw the two
Screws (7) into the two Legs (4) and Brace (3).
Insert one of the Legs (4) halfway into one of the
T-joint
assembled in step 1. Insert the other Leg halfway into the
Socket Press down on both Legs at the same time and fully
insert them into the Sockets and T-joint
Note: You may need to pull outward on the Legs as you insert
them into the Sockets and T-joint
Repeat above steps until the six assembled leg sections (E)
4
3
Push Here
Push Here
Pull
Here
Pull
Here
Peak
7
14
14
15
15
16
16
16
16
7
4
Then connect the leg and Top Tube by inserting
two M4X50mm Bolts(14), four M4 washer(16) and two M4
Locknuts(15)
Notice:do not tighten the locknuts
5.
Note: This step requires two persons
. During this
step, you will connect the six assembled leg sections
together.
Stand two leg sections(E) and hold them in the positions
shown, then attach them.
Repeat this step until all six leg sections are connected.
When this step is completed, tighten all the Bolts and Locknuts.
The frame will be fully assembled and freestanding
5
2
2
1
2
1
1
1
2
2
2
1
1
1
2
2
hole
18
17
12
Key No2
17
13
18
Key No2
Large end
Small end
1
