The board controller need to be fully charged before your first use. Before charging make sure both
the board and the charger are powered off.
The controller uses a standard micro USB to USB cable to charge.
Plug the board controller micro USB cable into the bottom of the controller. Plug the USB end into the
charger and into an outlet. It takes about 2 hours to fully charged the remote.
Once the controller is powered on, you can toggle between froward and reverse by pressing the power
button once.
PAIRING THE CONTROLLER
For the first use, the board and controller need to be paired together.
Before starting make sure the board and controller are turned off.
Press and hold the power switch on the board and the power switch on the controller until you hear 3 beeps.
The board and controller should now be paired. If not, repeat until they are paired.
08
The Controller
