7
D-ring 6
13. Attach the Straps w/Clip on Each End (7) as follows:
Clip one end of a Straps w/Clip on Each End (7)
into a D-ring sewn on the Jump Mat w/D-rings (6). Pull
the strap until it reaches the frame.
Then wrap the strap around the frame and through the
next closest D-ring continuing in this manner until you
reach the end of the strap. Attach the clip at the end of
the strap to the closest D-ring. Attach the other three
Straps w/Clip on Each Ends (7) to the frame in the
same manner, starting the new strap on the D-ring the
previous strap ended. When finished, pull all the straps
to tighten.
If the strap is a little too long, please continue to wrap
as before until the end of the strap is reached.
Remove the four Elastics with balls (30).
Note: if the Mat w/D-rings (6) is not sitting in the middle
of the frame, you will need to adjust it by pulling the
straps until it sits properly.
Caution: It is wise to wear leather gloves while
attaching the straps.
frame
hook
6
29
14. Lay the Frame Cover (29) on the Mat w/D-rings (6).
Adjust the position of the frame cover (29) so that the
zipper can be directly connected. Attach the frame
cover (29) to the Mat (6) with the zipper.
Caution: Do not use the Skybed without the frame
cover (29). The frame cover is designed to reduce
the possibility of injuries due to user coming in
contact with the frame. Make sure to properly install
the frame cover before using the Skybed.
If you do not have a frame cover, contact your dealer
to obtain one.
14
