ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
• Need phillips screw driver and 2 adjustable wrenches (putting the trampoline together). A rubber mallet may make assembly
easier, however.
• Assembly requires two persons.
• Wear gloves to protect your hands from pinch points during assembly.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface before using it.
2. Adequate overhead clearance is essential. A minimum of 24 feet from ground level is best. Provide clearance for wires, tree
limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline away from walls, struc-
tures, fences, and other play areas. Always have a clear space on all sides of the trampoline.
3. Use the trampoline in a well-lighted area. Electric lights may be required for shady areas.
4. Secure the trampoline against unauthorized and unsupervised use.
5. Remove any objects from beneath the trampoline.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
1. Make sure that you understand the information in the
box at the top of this page.
Lay two Top Tubes with attached sockets (2) (A and C in
the inset drawing) and one top tube (1) without socket (B
in the inset drawing) on the ground in the positions
shown. Make sure the Top Tubes are turned so the small
holes (spring holes) are facing the ground.
Insert one end of the Top Tube without socket (B) into
the socket of Top Tube C. Insert the opposite end of the
Top Tube without socket (B) in the end of Top Tube with
socket (A). The Top Tubes and Sockets should now
appear as shown in step 2, below.
2. Slide two Leg Extensions (3) onto a Brace (4) as
shown. The peak of the Brace (4) should point toward the
ground. Screw the two screws (8) into the legs (3) and
Brace (4).
Insert one of the Legs (3) halfway into one of the Sockets
(2) assembled in step 1. Insert the other Leg halfway into
the other Socket. Press down on both Legs at the same
time and fully insert them into the Sockets.
Note: You may need to pull outward on the Legs as you
insert them into the Sockets.
Repeat steps 1 and 2 three additional times to assemble
the remaining three leg sections.
1
2
2
2
3
4
3
Push Here
Push Here
Pull
Here
Pull
Here
Peak
2
8
8
11
A
B
C
