TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with either the fireplace itself or with the remote. Review
the fireplace manufacturer’s operation manual to make sure all connections are properly made. Then check the operation of the
remote in the following manner:
Make sure all batteries are correctly installed in the transmitter. Also check that the batteries are fully charged.
•
Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure receiver and transmitter are within 20’-25’ operating range.
•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
•
Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING TRANSMITTER TO
•
RECEIVER section).
LEARNING TRANSMITTER TO RECEIVER
This transmitter has one of 1,048,576 unique security codes. It may be necessary to program the remote receiver to “learn” the security
code of the transmitter upon initial use, if batteries are replaced, or if using a replacement transmitter.
Make sure the receiver’s slide switch is in the
•
REMOTE
position.
Press and release the
•
LEARN
button on the receiver.
When you hear the “Beep”, press and hold the
•
MODE
button for about 2 seconds on the transmitter.
You will then hear a series of beeps that indicate that your new transmitter has been accepted by the receiver.
•
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
For Technical Service, call:
U.S. INQUIRIES
888/672-8929 or 260/459-1703
Web site: www.skytechsystem.com
CANADIAN INQUIRIES
877/472-3923
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
REV. 5-8-13 Page 5
Skytech Smart Stat III
