REV. 3-19-20 Page 6
Skytech: RCTS-MLT-IV
TRANSMITTER WALL BRACKET
The transmitter can be hung on a wall using the clip provided.
•
Wood - Drill 1/8’’ pilot holes and install with screws provided.
•
Plaster/Wallboard - Drill 1/4’’ holes, tap in anchors in with hammer, then
install with the screws provided.
Slide Transmitter
down into holder
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter and receiver should
be at least 12 months. Check and replace all batteries:
•
Annually.
•
When operating range becomes reduced.
•
When transmissions are not received by the remote receiver..
•
If the hand held transmitter batteries measure less than 2.4 volts (Both
batteries in combination).
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept the transmitter
security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. In
order for the receiver to accept the transmitter security code, be sure the slide button on the receiver is in the REMOTE position; the
receiver will not LEARN if the slide switch is in the ON or OFF position. The LEARN button in located on the front face of the receiver;
inside the small hole labeled LEARN. Using a small screwdriver or end of a paperclip gently Press and Release the black LEARN
button inside the hole. When you release the LEARN button the receiver will emit an audible “beep”. After the receiver emits the beep
press the transmitter MODE button and release. The receiver will emit several beeps indicating that the transmitter’s code has been
accepted into the receiver.
TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with either the fireplace itself or with the remote. Review
the fireplace manufacturer’s operation manual to make sure all connections are properly made. Then check the operation of the
remote in the following manner:
•
Make sure all batteries are correctly installed in the transmitter. Also check that the batteries are fully charged.
•
Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure receiver and transmitter are within 20 to 25-foot operating range.
•
Keep receiver from temperatures exceeding 170º F.
•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
•
Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING TRANSMITTER TO
RECEIVER section).
