REV. 3-19-20 Page 3
Skytech: RCTS-MLT-IV
MOUNTING THE REMOTE RECEIVER
HEARTH MOUNT
•
The remote receiver can be placed on the fireplace hearth or under the fire-
place behind the control access panel.
• MAKE SURE THAT WHERE THE RECEIVER IS PLACED DOES NOT
EXCEED 170ºF. IT WILL CAUSE DAMAGE TO THE PRODUCT.
•
Use the wires attached to the remote receiver to connect to the gas valve or
the electric module.
•
Be sure that the connectors do not touch each other or other bare metal
surfaces; this will cause the appliance to turn on. The connectors may be
wrapped with electrical tape to prevent this.
WIRING INSTRUCTIONS
A qualified electrician should install the remote control system.
WIRING MILLIVOLT VALVES
INSTALLATION
Before installation make sure the remote receiver slide switch is in
the
OFF
position. After installation be sure that the slide switch is
moved to the
REMOTE
position.
•
Connect one wire from the remote receiver valve connection to
the TH terminal on the gas valve.
•
Connect the other wire from the remote receiver valve
connection to the TH/TP terminal on the gas valve.
MILLIVOLT SYSTEM CHECK
•
Ensure that the pilot flame is lit.
•
Slide the 3-position button on the remote receiver to the
ON
position. The main gas flame (i.e., the fire) should ignite.
•
Slide the button to
OFF
. The main flame should extinguish (the
pilot flame will remain on).
•
Slide the button to
REMOTE
, then select
ON
with the mode
button on the transmitter to change the system to on. The main
gas flame should ignite.
WIRING ELECTRONIC SPARK IGNITIONS
Take both switch/thermostatic wires from the
Electronic Module, and connect them to the
receiver wires using the spade connectors.
NOTE: An adapter may be necessary
to make the connection between the
Electronic Module and the Remote
Receiver.
OFF-RE
MOTE-O
N
GROUN
D
VALVE
LEARN
CONTR
OL
FLAME
Fan Outlet Back
Side of RX
FAN
CONTROL
TERMINAL BLOCK
ON MILLIVOLT
GAS VALVES
TH
TP
TP
TH
THERMOPILE/
PILOT LIGHT
OFF-REMOTE-ON
GROUND
VA
LV
E
FLAME CONTROL
LEARN
REMOTE
RECEIVER
FAN OUTLET
FA
N
CONTR
OL
I
S
Electronic
Module
Piggyback
Connectors
Switch
Wires
OFF-REMOTE-ON
GROUND
VA
LV
E
FLAME
CONTROL
LEARN
REMOTE
RECEIVER
FAN
OUTLET
FA
N
CONTR
OL
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before attempt-
ing installation. Follow instructions carefully during installation. Any modifications of this remote control or any of its components will
void the warranty and may pose a fire hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance manufacturer’s instructions
and wiring schematics for proper placement of all wires. All electronic modules are to be wired to manufacturer’s specifications.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/or electronic
module for correct wiring procedures. Improper installation of electric components can cause damage to electronic module, gas valve
and remote receiver.
WARNING
