MOUNTING THE REMOTE RECEIVER
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fire-
•
place behind the control access panel.
MAKE SURE THAT WHERE THE RECEIVER IS PLACED DOES NOT
•
EXCEED 170ºF. IT WILL CAUSE DAMAGE TO THE PRODUCT.
Use the wires attached to the remote receiver to connect to the gas valve or
•
the electric module.
Be sure that the connectors do not touch each other or other bare metal
•
surfaces; this will cause the appliance to turn on. The connectors may be
wrapped with electrical tape to prevent this.
OFF REMO
TE ON
LEARN
GROUND
VALV
E
FLAM
E
CONTROL
WIRING INSTRUCTIONS
A qualified electrician should install the remote control system.
WIRING MILLIVOLT VALVES
INSTALLATION
Before installation make sure the remote receiver slide switch is in the
OFF
position. After installation be sure that the slide switch is
moved to the
REMOTE
position.
TERMINAL BLOCK
ON MILLIVOLT
GAS VALVES
TH
TP
TP
TH
THERMOPILE/
PILOT LIGHT
REMOTE
RECEIVER
Connect one wire from the remote receiver’s “valve” connection
•
to the TH terminal on the gas valve.
Connect the other wire from the remote receiver’s “valve”
•
connection to the TH/TP terminal on the gas valve.
MILLIVOLT SYSTEM CHECK
Ensure that the pilot flame is lit.
•
Slide the 3-position button on the remote receiver to the
•
ON
position. The main gas flame (i.e., the fire)
should ignite.
Slide the button to
•
OFF
. The main flame should extinguish (the pilot flame will remain on).
Slide the button to
•
REMOTE
, then press the
ON
button on the transmitter to change the system to on. The main
gas flame should ignite.
WIRING ELECTRONIC SPARK IGNITIONS
I
S
Electronic
Module
Piggyback
Connectors
Switch
Wires
REMOTE
RECEIVER
ELECTRONIC SPARK SYSTEM CHECK
Slide the 3-position button on the remote receiver to the
•
ON
position. The spark electrode should begin sparking to ignite the pilot.
After the pilot flame is lit, the main gas valve should open and the main gas flame should ignite.
Slide the button to
•
OFF
. The main gas flame and pilot flame should both extinguish.
Slide the button to
•
REMOTE
, then select “ON” with the mode button on the transmitter to change the system to on. The spark
electrode should begin sparking to ignite the pilot. After the pilot is lit, the main gas valve should open and the main gas flame
should ignite.
Take both switch/thermostatic wires from the Electronic
Module, and connect them to the receiver wires using
the spade connectors.
NOTE: An adapter may be necessary to
make the connection between the Electronic
Module and the Remote Receiver.
Skytech: RCT-MLT III
REV 12-26-13 Page 3
