AUTO SHUT DOWN
This remote control has an auto shut down feature incorporated into its system. When the transmitter mode is in the ON position, the
appliance will only run for 9 hours. After that it will shut down. To reactivate the appliance, press the
MODE
button.
CP (CHILDPROOF) FEATURE
This remote control includes a childproof feature that allows the user to “lock-out” operations from the transmitter.
To activate and de-activate the childproof feature, press and hold the
•
SETTING
button
behind the battery cover, for 5 seconds
(SEE The letters “CP” will briefly appear on the LCD screen when childproof mode is activated).
“CP” will appear on the LCD screen if any button is pressed while childproof mode is engaged.
•
When this mode is engaged, all auto settings go on without interruption (like thermostat). Only manual functions are prevented.
•
TRANSMITTER WALL BRACKET
The transmitter can be hung on a wall using the clip provided.
Wood - Drill 1/8’’ pilot holes and install with screws provided.
•
Plaster/Wallboard - Drill 1/4’’ holes, tap anchors in with hammer, then
•
install with the screws provided.
Slide Transmitter
down into holder
BATTERY LIFE
Life expectancy of the alkaline batteries in the transmitter should be at least 12 months. Check and replace all batteries:
Annually.
•
When operating range becomes reduced.
•
When transmissions are not received by the remote receiver..
•
If the hand held transmitter batteries measure less than 2.4 volts (Both batteries in combination).
•
LEARNING TRANSMITTER TO RECEIVER
This transmitter has one of 1,048,576 unique security codes. It may be necessary to program the remote receiver to learn the security
code of the transmitter upon initial use, if batteries are replaced, or if using a replacement transmitter.
Make sure the receiver’s slide switch is in the
•
REMOTE
position.
Press and release the
•
LEARN
button on the receiver.
When you hear the “Beep”, press and hold the
•
MODE
button for about 2 seconds on the transmitter.
If you not hear a beep after you press the
•
LEARN
button, check that the batteries in the receiver are installed correctly and fully
charged.
You will then hear a series of beeps that indicate that your new transmitter has been accepted by the receiver.
•
Skytech: RCT-MLT III
REV 12-26-13 Page 5
