REV. 10/29/03
Page 6 of 6
TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with the fireplace itself or it could be with the CON 1001 TH remote
system. Review the fireplace manufacturer's operation manual to make sure all connections are properly made. Then check the operation of
the remote in the following manner:
•
Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from operating properly.
•
Check battery in TRANSMITTER to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure RECEIVER and TRANSMITTER are within 20'-25' operating range.
•
Keep RECEIVER from temperatures exceeding 130° F. Battery life shortened when ambient temperatures are above 115° F.
•
If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.
NOTE: A receiver located in an area, where the ambient temperature inside the case exceeds 130° F, will cause the THERMO-SAFETY
feature to cut in, requiring you to reposition the receiver to stop the warning beeps, and to "reset" the receiver's operation.
•
Due to handling and shipping of the unit, handling or dropping of the transmitter by the customer, and/or heat conditions at the receiver,
some receivers may need an occasional frequency adjustment. This adjustment is made to improve the communication and operating
distance between the transmitter and the receiver. Follow the steps below for making the adjustment.
FREQUENCY (DISTANCE) ADJUSTMENT PROCEDURE
RECEIVER ADJUSTMENT
1. To adjust at the receiver, use a small slotted screwdriver. Turn the adjustment (ADJ)
screw counter-clockwise about 5° or maximum of 1/8 turn. This should correct the
distance problem.
2. If that does not correct the problem, return adjustment screw to original position and then
turn adjustment screw clockwise.
This adjustment is like tuning your radio. If you keep turning the adjustment screw, in either
direction, you will go past the proper setting (tuning).
SPECIFICATIONS
BATTERIES:
Transmitter (2) 1.5 volt AAA t bateries
Remote Receiver 6V - 4 ea. AA 1.5 Alkaline
FCC ID No.'s: transmitter - K9L1003TX; receiver - K9L300IRX
Operating Frequency: 303.8 MHZ
Canadian IC ID No.'s: transmitter – 2439-1003TX; receiver - 2439 102 728A
FOR TECHNICAL SERVICE, CALL:
U. S. INQUIRIES
CANADIAN
INQUIRIES
888/672-8929
or
877/472-3923
260/459-1703
WEBSITE:
skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC.
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
WARRANTY
All warranty information is listed on the warranty sheet packed with this product. If you did not
receive this warranty sheet, please contact Skytech Systems, Inc. at the following:
9230 Conservation Way, Fort Wayne, IN 46809
(888) 672-8929 or (260) 459-1703
www.FireplaceRemoteControls.com
1.877.374.4404
