Skytech: 5320
REV. 7-25-18 Page 9
GENERAL INFORMATION
THERMO FUNCTION
When the transmitter is in the THERMO mode, it should be kept away from direct sources of heat such as fireplaces, in-
candescent lighting, and direct sunlight. Leaving the transmitter in direct sunlight, for example, will cause its heat-sensing
diode to read the room temperature higher than it actually is; if in THERMO mode, it may not turn on the appliance even if
the ambient ROOM temperature is below the SET temperature.
BATTERY LIFE
Life expectancy of alkaline batteries in the SKYTECH 5320 should be at least 12 months. Check and replace all batteries
annually. When the Transmitter no longer operates the receiver from a distance it did previously (i.e., the
transmitter’s range has decreased) or the remote receiver does not function at all, the transmitter batteries should be
checked. The Transmitter should operate with as little as 5.0 volts of battery power, measuring total voltage of the
(4) 1.5-volt batteries.
TRANSMITTER WALL MOUNT
The transmitter can be placed on a wall using the mount provided.
Wood - Drill 1/8’’ pilot holes and install with screws provided.
Plaster/Wallboard - Drill 1/4’’ holes, use a hammer to tap in the two plastic
anchors. Then install with the screws provided.
