Skytech: 5320
REV. 7-25-18 Page 8
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press
the LEARN button on the receiver to accept the transmitter security code
upon initial use, if batteries are replaced, or if a replacement transmitter is
purchased from your dealer or the factory. In order for the receiver to
accept the transmitter security code, be sure the slide button on the
receiver is in the REMOTE position; the receiver will not LEARN if the slide
switch is in the ON or OFF position. The LEARN button in located on the
front face of the receiver; inside the small hole labeled LEARN. Using a
small screwdriver or end of a paper clip gently press and release the black
LEARN button inside the hole. When you release the LEARN button the
receiver will emit an audible “beep”. After the receiver emits the beep press
the transmitter MODE/SET button and release. The receiver will emit
several beeps indicating that the transmitter’s code has been accepted into
the receiver.
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are
unsuccessful in matching the security code on the first attempt, wait 1-2 minutes before trying again – this delay allows
the microprocessor to reset its timer circuitry – and try up to two or three more times.
SYSTEM CHECK
MILLIVOLT VALVES
Light your gas appliance following the lighting instructions that came with the appliance. Confirm that the pilot flame is
ON; it must be in operation for the main gas valve to operate.
• Slide the 3-position button on the remote receiver to the ON position. The main gas flame (i.e., the fire) should ignite.
• Slide the button to OFF. The flame should extinguish (the pilot flame will remain on).
• Slide the button to REMOTE (the center position) then press the MODE/SET button on the transmitter to change the
system to ON. The main gas flame should ignite.
ELECTRONIC IGNITION SYSTEMS
• Slide the 3-position button on the remote receiver to the ON position. The spark electrode should begin sparking to
ignite the pilot (the pilot may ignite after only one spark). After the pilot flame is lit, the main gas valve should open
and the main gas flame should ignite.
• Slide the button to OFF. The main gas flame and pilot flame should BOTH extinguish.
• Slide the button to REMOTE (the center position), and then press the MODE/SET button on the transmitter to change
the system to ON. The spark electrode should begin sparking to ignite the pilot. After the pilot is lit, the main gas
valve should open and the main gas flame should ignite.
WARNING
THIS REMOTE CONTROL SYSTEM MUST BE INSTALLED EXACTLY AS OUTLINED IN THESE INSTRUCTIONS.
READ ALL INSTRUCTIONS COMMPLETELY BEFORE ATTEMPTING INSTALLATION. FOLLOW INSTRUCTIONS
CAREFULLY DURING INSTALLATION. ANY MODIFICATION OF THIS REMOTE CONTROL OR ANY OF ITS
COMPONENTS WILL VOID THE WARRANTY AND MAY POSE A FIRE HAZARD.
LEARN
