NOTE
: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is
in the (middle) REMOTE position. If the system does not respond to the battery transmitter on initial use, see LEARNING
TRANSMITTER TO RECEIVER section, and re-check battery positions in the remote receiver.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace,
behind the control access panel or louvers. Position where the ambient temperature
inside the receiver case does not exceed 130°F.
NOTE
: Slide Button (included) is
used for Hearth Mount applications (Fig. 15).
Fig. 15 Receiver
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
WIRING INSTRUCTIONS
A qualified electrician or a gas technician who is trained with gas appliances and gas valves that will be operated by this
remote should install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or
electronic module operating the gas appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver must be connected to the millivolt valve at the
TH
&
TH/TP
(thermostat) terminals on the terminal
block on the millivolt gas valve. Connect 18 gauge stranded or solid
wires from the remote receiver to the gas valve.
Operation of the remote receiver is similar to that of a thermostat
in that both turn the gas valve on and off based on input signals. A
thermostat’s input signals are different temperatures. The remote
receiver’s input signals come from the transmitter.
Connect one black wire to the
TH
terminal and the other black wire
to the
TH/TP
terminals on the millivolt gas valve. Normally it does
not matter which wires go to which terminal (Fig. 16).
!
WIRING ELECTRONIC SPARK IGNITIONS
The remote control receiver can be connected, in series, to a
24VAC transformer to the
TR
(transformer) terminal on the ELEC-
TRONIC MODULE. Connect the hot wire from the 24VAC trans-
former to either of the wire terminals on the remote receiver. Con-
nect another wire (not included) between the other receiver wire
terminal and the
TH
(thermostat) terminal on the ELECTRONIC
MODULE (Fig. 17).
Fig. 16 Millivolt Gas Valve Wiring
!
Fig. 17 Electronic Spark Wiring
Skytech: 3301P
REV. 2-7-12 Page 5
