Skytech: 3301-FSCRF
REV. 8-21-20 Page 3
Flip down the plastic cover on the front of the transmitter to expose the “SET” buttons (Fig. 1). The flip cover protects the
SET buttons from being changed accidentally. Close the cover after completing the following settings/programming.
Blinking numbers on the LCD display indicate the system is awaiting user input, such as using the UP and DOWN buttons
to program a new setting. If no change is made to flashing digits within 15-seconds, the system will complete the proce-
dure last programmed and reset the display to its normal state.
SETTING UP THE TRANSMITTER
SETTING THE CLOCK
1. Press and hold the TIMER/TIME button on the transmitter
for more than 2-seconds. The hour digit(s) will begin
blinking.
2. Press the UP or DOWN button until the desired hour is
displayed in AM or PM.
3. After setting the desired hour, press and release the TIMER/
TIME button again to set the minutes; the minute digits will
begin blinking.
4. Press the UP or DOWN button until the desired minutes are
displayed.
5. Press and hold the TIMER/TIME button again for more than
2-seconds. The time digits will cease flashing, indicating the
clock has been successfully set. You may also press the
SET button on the transmitter to stop the time digits from
blinking and set the time.
DOWN
UP
MODE
SET
TIME
TIMER
COVER OPEN
Fig. 7
Timer/Time Button
ROOM
SET
ROOM
SET
Fig. 8
Setting Hours
Fig. 9
Setting Minutes
The factory setting for temperature is ºF. To change this setting to ºC, first press and hold
the UP and DOWN buttons on the transmitter at the same time. Follow this same procedure
to change from ºC back to ºF. When changing between the ºF and ºC scales, the
temperature in the SET frame defaults to the lowest temperature (45º F, or 6º C). The
highest SET temperature is 99º Fahrenheit (32º Celsius).
SETTING ºF / ºC SCALE
DOWN
UP
MODE
SET
TIME
TIMER
COVER OPEN
Fig. 10
Temperature Scale
