REV 8-14-17 Page 5
Skytech: 3002P
REMOT
E
O
N
O
F
F
LEARN
WALL
Plastic Switch Box
Remote Receiver
Wall cover plate
& Transmitter holder
Receiver
Slide
Button
Fig. 14 Install Cover Plate into Box
NOTE
: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is
in the (middle) REMOTE position. If the system does not respond to the battery transmitter on initial use, see LEARNING
TRANSMITTER TO RECEIVER section, and re-check battery positions in the remote receiver.
HEARTH MOUNT
The remote receiver can be placed on the fi replace hearth or under the fi replace,
behind the control access panel or louvers. Position where the ambient temperature
inside the receiver case does not exceed 130°F.
NOTE
: Slide Button (included) is
used for Hearth Mount applications (Fig. 15).
Fig. 15 Receiver
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
WIRING INSTRUCTIONS
A qualifi ed electrician or a gas technician who is trained with gas appliances and gas valves that will be operated by this
remote should install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or
electronic module operating the gas appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver must be connected to the millivolt valve at the
TH
&
TH/TP
(thermostat) terminals on the terminal
block on the millivolt gas valve. Connect 18 gauge stranded or solid
wires from the remote receiver to the gas valve.
Operation of the remote receiver is similar to that of a thermostat
in that both turn the gas valve on and off based on input signals. A
thermostat’s input signals are different temperatures. The remote
receiver’s input signals come from the transmitter.
Connect one black wire to the
TH
terminal and the other black wire
to the
TH/TP
terminals on the millivolt gas valve. Normally it does
not matter which wires go to which terminal (Fig. 16).
Fig. 16 Millivolt Gas Valve Wiring
Position the cover plate so the word
ON
is facing up
(Fig. 14); then, install the remote receiver into the plastic
switch box using the two long screws provided. Push
the slide button over the receiver slide switch only
after making sure the remote receiver has LEARNED the
transmitter’s security code (see LEARNING
TRANSMITTER TO RECEIVER).
