REV 8-14-17 Page 11
Skytech: 3002P
SET TEMPERATURE HOLD
– (PROGRAM mode only)
The user may override the SET temperature during any period,
adjusting the SET temperature to a CONSTANT new SET/HOLD
temperature.
1. Press the UP or DOWN button to change the SET temperature to
the level desired. The word OVERRIDE will appear in SET frame
on the LCD.
2. To HOLD the new temperature at a CONSTANT setting, push the
UP and DOWN buttons “
at the same time”
to activate the HOLD
function. The word HOLD will appear over the SET frame and the
word OVERRIDE will disappear.
3. To cancel OVERRIDE or HOLD, press the SET button.
TIME OF DAY DISPLAY
1.
To check the current TIME of day, press the TIMER/TIME
button on the transmitter for less than 1 second. The current
TIME of day will appear in the TIME/TEMP frame replacing the
temperature reading.
2.
The TEMPERATURE will reappear in 15 seconds, or you can
press the SET button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with the built-in, countdown timer
when the transmitter is in the ON or THERMO mode
(THERMO or
ON must be displayed on the LCD screen)
. DO NOT operate in
PROGRAM MODE, because time is pre-programmed into the
transmitter.
1.
Press the TIMER/TIME button on the transmitter for more than
2 seconds. The word TIMER and 0:15 flash on the LCD screen.
2.
Press the UP or DOWN button on the transmitter to begin
advancing through each of the countdown time options.
Available count down times are 15 min., 30 min, 45 min, 1 hr,
1 hr 30 min, 2 hr, 2 hr 30 min, and each additional half hour up to
nine hours.
3.
To set the TIMER press the SET button on the transmitter. If the system is ON, it will remain on until the “timer” has
expired. If the system is in the THERMO mode, it will cancel ON and OFF, as the room temperature requires until the
“timer time” has expired.
4.
To cancel the TIMER operation, press the TIMER/TIME button for more than 2 seconds.
OPERATIONAL NOTE:
When the TIMER is used in the THERMO mode, the THERMO operation will be disabled until
the “countdown time” has expired, then normal THERMO mode will presume.
Fig. 27 Set Temperature Hold
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
Fig. 28 Time of Day
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
Fig. 29 Setting Timer
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
