REV 8-14-17 Page 1
Skytech: 3002P
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT
TO INSTALL OR OPERATE
Model: 3002P
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas
heating appliance. The system can be operated thermostatically, manually or with the built-in factory program inside the transmitter.
The built-in program will control the appliance (7) days a week with (4) continuous time periods for each day. SEE PROGRAM
SEQUENCE BELOW. Custom programming may be achieved after the initial set has been performed.
This system operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system operates one of
1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver’s code must be matched to that of
the transmitter prior to initial use.
Review
COMMUNICATION SAFETY
under the
TRANSMITTER SECTION
and
THERMO SAFETY
under the
REMOTE RECEIVER
SECTION.
These signal/temperature safety features shut down the appliance when a potentially unsafe condition exists.
INITIAL SET-UP OF TRANSMITTER
Fig. 1 Transmitter Front and Back Views
6:00AM
8:30AM
3:00PM
11:00PM
6:00AM
DAY
MORN
EVE
NIGHT
70°
60°
70°
63°
Built-in Factory Program
The transmitter operates on (2) AAA size 1.5V batteries. It is recommended that
ALKALINE
batteries always be used for longer
battery life and maximum operational performance.
IMPORTANT:
New batteries are essential for proper operation of the multi-function
transmitter.
The initial set-up of the transmitter is
IMPERATIVE
to ensure
the following:
•
Current Time - Hours and Minutes / AM/PM
•
Current Day of the Week - S, M, T, W, T, F, S
•
Temperature Scale - F° (Fahrenheit) or °C (Celsius)
To begin the initial set-up proceed with the
following steps:
1.
Remove the battery cover on the back of the transmitter.
Insert (2)
ALKALINE
AAA size 1.5 DCV batteries into the
battery compartment, positioning the (+) and (-) ends of the
batteries as indicated on the casing. When the batteries are
inserted properly, the LCD screen will display.
2
. Note the small button at the upper left side of the battery
compartment (Fig. 1). This is the setting button used to
perform the initial transmitter set-up.
MODE
COVER CLOSED
MODE
TIMER
TIME
SET
SLIDE COVER
OPEN
+
+
-
-
AAA
BACK OF
TRANSMITTER
SETTING
BUTTON
