_________________________________________________________________________________________________
REV. 12-26-13 Page 2 of 3
Skytech 1001D-TX
RECEIVER/MODULE
Install the (4) AA-size batteries supplied with the unit. It is recommended
that ALKALINE batteries always be used for this product.
Be sure the
batteries are installed with the (+) and (-) ends facing the correct
direction.
The remote receiver/module has a 3-position slide switch for selecting the
mode of operation
ON/REMOTE/OFF
•
ON
: will manually turn ON the appliance.
•
REMOTE
: will allow use of handheld transmitter. If the system does not respond to the transmitter on initial use,
check the battery positions in the remote. If that does not work, see the LEARNING TRANSMITTER TO
RECEIVER/MODULE section.
•
OFF
: will disable the remote receiver/module.
•
It is suggested that the slide switch be placed in the OFF position if you will be away from your home for an
extended period of time.
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before
attempting installation. Follow instructions carefully during installation. Any modifications of this remote control or any of its
components will void the warranty and may pose a fire hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance manufacturer’s instructions
and wiring schematics for proper placement of all wires. All electronic modules are to be wired to manufacturer’s specifications.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/or electronic
module for correct wiring procedures. Improper installation of electric components can cause damage to electronic module, gas valve
and remote receiver.
GENERAL INFORMATION
LEARNING TRANSMITTER TO RECEIVER/MODULE
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver/module to
accept the transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased
from your dealer or the factory. In order for the receiver to accept the transmitter security code, be sure the slide button
on the receiver/module is in the REMOTE position; the receiver/module will
not
LEARN if the slide switch is in the ON or
OFF position. The LEARN button in located on the front face of the receiver or on the side of the module; inside the small
hole labeled LEARN. Using a small screwdriver or end of a paperclip gently press and release the black LEARN button
inside the hole. When you release the LEARN button the receiver/module will emit an audible “beep”. After the
receiver/module emits the beep press the transmitter
ON
or
OFF
button for approximately 2 seconds and release. The
receiver/module will emit several beeps indicating that the transmitter’s code has been accepted into the receiver/module.
REMOTE
ON
OFF
LEARN
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Battery cover slides on/off
Slide
Switch
ON
REMOTE
OFF
!
AF-4000 Module Lt Side
Learn Button
!
