CARBURETOR IDLE SPEED CHECK AND
ADJUSTMENT
(1) Start up the engine and warm it up.
(2) When the engine is warm, turn the adjusting
screw in or out so that the engine may run at its idle
speed shown in “SPECIFICATIONS”
NOTE:
The engine idle speed adjustment should be
carried out when the engine is in warmed state.
CAUTION:
.It is suggested that this adjustment be
conducted by approved SKYTEAM dealer.
.You can do it yourself with the above
procedures if a speedometer is available.
THROTTLE CABLE ADJUSTMENT
As the figure shown: there is 0.5~1mm slack at the
throttle cable. Adjust the throttle cable according to
following instruction:
Hold the throttle cable hose to check the slack.
Loosen the lock nut and adjust the cable slack by
turning adjuster in or out to obtain the correct slack.
After adjusting the slack, tighten the lock nut (1).
idle speed adjusting screw
33
DRIVE CHAIN
It is suggested that the worn chain replacement be
conducted by approved SKYTEAM dealer.
When performing the periodical check, the
following states of drive chain should be checked.
(1) Loose pins
(2) Damaged rolls
(3) Dry and rusty chain links
(4) Excessive damage
(5) Twisted and binding links
(6) Loose drive chain
If the above troubles found, the sprocket is most
probably to be damaged. Therefore the following
check of the sprocket is necessary:
WARNING!
In order to assure the maximum safety,the drive
chain check and adjustment should be carried
out before the riding.
(1) Excessively damaged sprocket teeth.
(2) Broken or damaged sprocket teeth.
(3) Loose lock nuts of the sprocket.
DRIVE CHAIN ADJUSTMENT
Adjust the drive chain and let it to be in normal
condition. As the riding condition, the drive chain
adjustment should be more frequent than that of
complete motorcycle.
WARNING!
Excessive chain slack could cause the chain
to come off the sprockets and result in an
accident or serious engine damage.
34