Cockpit Kit Assembly
1. Make two ¼ x ¼ balsa crutches by splicing pieces of 36” balsa
stock to length.
2. Pin the ¼ x ¼ crutches in place on the plans.
6. Glue C1A and C1B together.
7. Glue both C6 Pedestal sides to the cockpit floor. Angle the sides
inward so they touch at the top.
8. Glue C7 Aft Pedestal Cover and C8 Forward Pedestal Cover to the
pedestal sides.
9. Glue C9 Rudder Pedal Supports to the cockpit floor along the
scribed lines.
10. Glue C10 Rudder Pedels to C9 and the cockpit floor as shown.
Note: Painting the cockpit pieces prior to installation in most
cases will be much easier than trying to paint them after
installing. Check color guide at the end of this supplement
for painting tips.
S-1
3. Glue F1A in place.
4. Glue F2A in place (note that F1A is angled slightly for engine right
thrust)
5. Glue F3A thru F6A in place. Do not remove the lightening holes
from F4A or F6A. Discard F5A. Continue with F6A thru F14A and
glue in place.
11. Glue the cockpit floor assembly to the fuselage assembly
between F4A and F6A.
