31. Continue the sheeting forward, but leave an open-
ing as shown. You will need access to this area
when mounting the wing.
32. Trim and sand the sheeting at F15, F12B, and the
wing saddle.
33. Lay the wing in the saddle and align. Trim the sad-
dle as necessary for a good fit.
34. With the wing aligned, slide F23 over the wing
dowel and epoxy to F2B.
35. Sheet the remainder of the forward fuselage.
36. Align the wing and drill and install the wing hold-
down bolts.
37. With the wing in place, fit and glue F2C to the lead-
ing edge of the wing.
38. Glue two W21s together. Fit and glue to F2C and
the bottom of the wing. Trim and sand to match the
fuselage.
1. Glue S1 and S2 together.
2. Trail fit this assembly to the tail section - trim as nec-
essary.
3. With the S1/S2 assembly flat, glue the S3 spar, and
S4, S5, and S6 ribs.
4. Align and glue S3 thru S6 to the opposite side of the
vertical.
5. Glue S6 to the top of S1/S2.
Vertical Stabilizer Assembly
17
