·
25
26 ·
DISCHARGING OF LITHIUM BATTERY
Discharging of lithium battery
Number
of
cells
DEC
-
Batt type
Stop
elapsed
time
INC
+
Battery
voltage
DEC
Start
Enter
-
INC
+
Discharged
capacity
discharge
current
The value of discharge current on the left can not exceed 1C, and the value
on the right can not be under the voltage recommended by the manufacturer
to avoid deep discharging. Press START/ENTER for more than 3 seconds to
start discharging.
This shows the real-time status of discharging, you can press BATT
TYPE/STOP key to stop discharging.
INC
The processor detects voltage of one cell is too low.
The 4th cell was damaged. The value of voltage may be zero if disconnection
occurs.
Voltage balancing and monitoring in the discharge process
>
3
seconds
The
processor
monitors
voltage of each cell when the battery packs are during its storage and
discharging process. If voltage of any cell is abnormal, Ultimate 400W will show error message and
terminate the program forcibly. So if there is battery damage or disconnection, you can see the error
message and press INC to know which cell is damaged.
CHARGING NICD/NIMH BATTERY IN THE CHARGE MODE
DEC
-
Batt type
Stop
Elapsed
time
INC
+
DEC
Start
Enter
-
INC
+
Charged
capacity
Battery
type
Charge
current
Battery
voltage
This program is for charging of NiCd/NiMH batteries associated with R/C
models applications. You can press START/ENTER key to make it blink and
then INC or DEC to change the parameter value. Press START/ENTER key to
store the value.
The screen shows the real-time status. Press BATT TYPE/STOP key to end
the program. The sound will emitted to indicates the end of program.
Charging NiCd/NiMH battery in the charge mode
>
3
seconds
This program charge the battery using the current you set up. In the auto state,you should set up the upper
limit of the charge current to avoid damage by excessive feeding current. Some batteries of low resistance
and capacity can lead to higher current in the auto charging mode. But in the manual mode, it will charge
with the current you set. You can make it blink in the current field and press INC and DEC simultaneously to
swap between Auto and Manual Mode. NOTE: Allowable fast charge current: 1C-2C
Ultimate 400W
Ultimate 400W
