As default this charger will be set to typical user settings when it is connected to DC 11~18V for
the first time. The screen displays the following information in sequence and the user can change
the parameter on each screen.
If you need to alter the parameter value in the program, press
Start/Enter
key to make it blink
then change the value with
INC
or
DEC
key. The value will be stored by pressing
Start/Enter
key once.
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
INC
DEC INC
INC
DEC
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
User setup starting screen.
The screen displays the nominal voltage of Lithium battery. There are three kinds
of Lithium battery: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V). This is very important so
you have to check the battery carefully and set it up correctly. If it is different from
correct value the battery may be exploded during charge process.
IMAX-B6 recognize the cell count of Lithium battery automatically at the
beginning of charge or discharge process to avoid from erroneous setting by
user. But deeply discharged battery can be perceived incorrectly. To prevent the
error, you can set the time term to verify the cell count by the processor. Normally,
10 minutes are enough to perceive the cell count correctly. For the battery of
larger capacity, you may extend the time term. But if you set the time term to long
for the battery of smaller capacity, the charge or discharge process can be
finished within the time term with the erroneous cell count. This may cause the
fatal result. If the processor recognizes the cell count incorrectly at the beginning
of charge or discharge process, you may extend the time. Otherwise, you had
better use with the default value.
INITIAL PARAMETER SETUP (USERS SET UP)
12
