e660
13 ·
e660
· 12
BATT PROG/STOP Button:
It is used to stop the progress or go back to previous step/screen
- Button:
It is used to go through the menus and decrease the parameter value
+ Button:
It is used to go through the menus and increase the parameter value
ENTER/START Button:
It is used to enter parameter or store parameter on screen.
When you need to change the parameter value in the program, press
ENTER button to make it blink, and then press -/+ button to change the
value. After selecting the correct value, re-press the ENTER button to
store it. If there is another parameter to be changed on the same
screen, after confirming the first parameter value, you are free to change
the second when it's blinking.
To start charging after setting, long-press the ENTER button for around
3 seconds. To stop charging or go back to previous step/screen, press
the BATT/PROG button once.
After power on, the charger will enter into LiPo Balance Charge program
directly. You are free to change the modes (balance charge, charge, fast
charge, storage and discharge) or battery types. Select correct battery
type, proper mode and current before charging.
For better service to you, this charger can memorize your last operation.
For example, last time you set at 2.1A to charge a 3S LiPo battery, when
you turn on the charger to do charging once again, the specifications
you selected last time will be remembered and displayed directly. To
ensure the safety, the charging mode will always turn to balance charge
for LiPo batteries. Isn't this function cool enough?
Operation
Below are the procedures for you to follow to make the charger work,
which will take LiPo, NiMH and Pb batteries as the standard.
Connection
1) Connect to power source
SkyRC e660 comes with built-in power supply, you can connect it to
either AC power source (100-240V) or DC power source (11-18V).
2) Connect the battery
Before connecting, it is extremely important for you to confirm that the
parameters are set correctly. Incorrect setting may damage the battery,
even burst into flames or cause explosion. To avoid short circuits
between the two banana connectors, always remember to connect the
charge leads to SkyRC e660 first, and then get the battery connected to
the leads. Reverse the procedure when disconnecting the pack.
3) Balance socket
It is for Lithium battery in all modes.
The balance wire of the battery must be connected to the charger with
the black wire aligned with the negative mark. Always remember to keep
right polarity in the connection. Please refer to the wiring diagram below,
which shows a correct way for your LiPo battery connection in the
balance charge mode.
Connection
