e660
07 ·
e660
· 06
Warning and Safety Notes
Warning and Safety Notes
Following warnings and safety notes are critically important,
please refer to the instructions for maximum safety; Otherwise the
charger and battery can be damaged or even cause a fire.
Never leave the charger unattended when it is connected to power
source. If any malfunction is found, TERMINATE THE PROCESS
AT ONCE and refer to the instruction manual.
Keep the charger well away from dust, damp, rain, direct sunshine
and vibration. Never drop it.
To reduce the risk of damage to the power cord, always pull by
connector rather the cord. The allowable AC/DC voltage is 110-
240V AC and 11-18V DC respectively.
Operate on a hard flat nice clean smooth heat-resistant
noninflammable nonconductive surface in a well-ventilated area.
Never place the device on a carpet, car seat, or similar. Keep all the
inflammable volatile substances away from operating area.
Avoid mechanical vibration or shock as these may cause damage to
the device.
Never block the cooling fan or the air ventilation holes.
Remove all batteries and unplug the charging unit from the power
source when not in use.
Please make sure to know the specifications of the battery to be
charged or discharged to ensure it meets the requirements of this
charger. If the program is set incorrectly, the charger and battery may
be damaged. Fire or explosion may be caused due to overcharging.
Opening, disassembling, modifying, tampering with the unit may
invalidate its guarantee.
Do not misuse in any way! Use for intended purpose and function
only.
Standard Battery Parameters
Be very careful to choose the correct voltage for different types of
battery otherwise you may cause damage to the batteries. Incorrect
settings could cause the cells to fire or explode.
3.7V/cell
Nominal
Voltage
Min. Discharge
Voltage
Max Charge
Voltage
Storage
Voltage
Allowable
Fast Charge
3.7V/cell
4.2V/cell
3.8V/cell
≦
1C
LiPo
LiIon
3.6V/cell
4.1V/cell
≦
1C
3.3V/cell
3.6V/cell
3.3V/cell
≦
4C
LiFe
3.0-3.3V/cell 2.9-3.2V/cell 2.6-2.9V/cell
1.2V/cell
1.5V/cell
n/a
1C-2C
NiCd
1.2V/cell
1.5V/cell
n/a
1C-2C
NiMH
2.0V/cell
2.46V/cell
n/a
≦
0.4C
Pb
0.1-1.1V/cell 0.1-1.1V/cell
1.8V/cell
LiHV
3.7V/cell
4.35V/cell
3.85V/cell
≦
1C
3.1-3.4V/cell
Never attempt to charge or discharge following types of batteries
A battery pack which consists of different types of cells with different
manufacturers
A battery that is already fully charged or just slightly discharged
Non-rechargeable batteries (Explosion hazard)
Batteries that require a different charge technique from NiCd, NiMH,
LiPo or Gel cell (Pb, Lead acid)
A faulty or damaged battery
A battery fitted with an internal charge circuit or a protection circuit
Batteries installed in a device or electrically linked to other components
Batteries undeclared by the manufacturer to be suitable for the current
the charger delivers
Please bear the following points in mind before commencing
charging:
