Assembly & Operation Manual
RUDDERS
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Mark √ each step.
Fit horn to servo and centre servo. Cut horn to clear skin of fin.
Make up rudder pushrods (2).
Fit servo to fin. Feed the pushrod from trailing edge and fit to servo horn.
Trial fit rudder. Check length of pushrod. Adjust if needed.
Use the piano wire for rudder hinge.
Seucre rudder horn from base of rudder. Use loctide.
Check left and right deflection. If not enough deflection—trim fin post.
Repeat for other rudder.
NOTE: To service rudder servo it will be necessary to remove tail pipe. Make sure all
work fine before proceeding.
P-16
Photo 30
Photo 31
Photo 37
Photo 43
Photo 38
Photo 39
Photo 42
Photo 40
Photo 41
