NOTE: The spoilers are factory fitted. Please go over each bolt and make sure they are
loctide. Do not tighten too much as it will restrict movement.
Locate all items needed to complete wing. Fit 2 L-shape servo brackets to DS8911 servos.
Spoiler servo must be mounted with horns facing top surface. The horn must be furthest
away from control surface and furthest away for root.
Secure servo horns and centre servo’s with TX.
Secure extension wire. Use safety clips on joint. Secure
servo’s to wing. Use 4 servo screws.
NOTE: SLAT MUST BE DONE BEFORE FLAP
Fit 2 x L-brackets to JR DS3421 slat servo. Connect servos
and do radio setup. Note that outer slat must travel less than
inner slat. If your radio can not do—use different pins on
horn! (savox 1250 shown—same specs as JR)
Fit the other servo to inside of flap servo hole. (P22)
Make 2 pushrods for slat.
Dremel slots to clear pushrods.
Mark location of slat horn. Dremel slot ad glue horn.
Fit pushrods. Check travel. NOTE : travel must differ be-
tween inner and outer servo. See p23 and p24.
P-13
Assembly & Operation Manual
Photo 18
Photo 20
Photo 19
Photo 21
Photo 22
Photo 24
Photo 23
