Assembly & Operation Manual
RUDDER
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Mark √ each step.
Locate all parts needed for this section.
Make up rudder pushrods (2).
Fit wire belcrank in position. Fit belcrank over wire and
mark location of set screws. NB. Note the position of bel-
crank on wire.
Cut flat sections into wire and secure belcrank to wire with
loctide.
Fit servo to servo plate with 4 set screws.
Fit pushrods to servo horn and belcrank. Use safety clips.
Make sure servo horn and belcrank form 90 degree angle.
Trail fit rudder. Check left and right deflection. If not
enough deflection—trim fin post.
When correct—glue the pin hinges to rudder and fin
post.
Fir servo cover.
NOTE: To service rudder servo it will be necessary to re-
move tail pipe and split fuselage. Make sure all work fine
before proceeding.
P-16
Photo 30
Photo 31
Photo 29
Photo 32
