NOTE: The prototype model was flown with internal linkages. The installation in this man-
ual shows internal linkages for ailerons. You can also change it to outside linkages.
Locate all items needed to complete wings. Fit 2 L-shape servo brackets to 2 x JR DS8911
aileron servos.
Aileron servo must be mounted with horns facing top surface. The horn must be furthest
away from control surface and furthest away for root.
Secure servo horns and centre servo’s with TX.
Secure extension wire. Use safety clips on joint.
Secure servo’s to wing. Use 4 servo screws.
Draw a line perpendicular to hinge line. Mark location of aileron horn. Mill slot in root of
aileron. Take care not to damage hinge tape. Use 30 minute epoxy to glue control horns.
Note : Make sure horn is supported by balsa block inside the aileron root. If no balsa,
cut root of aileron and insert balsa before you glue the horn to aileron.
After epoxy cured, insert pushrods and secure safety clips.
Check operation of aileron.
Mill slot in servo cover and secure with 4 x 1mm set screws.
Repeat for other wing.
P-13
Assembly & Operation Manual
Photo 17
Photo 18
