To erase all remote controls and keypads, follow the instructions below.
1. Press and hold the SET button for 15 seconds, until the LED display
flashes “E”, release “SET” button.
2. Press “SET” button once to confirm, the “E” disappear on the LED
display. All remote controls and keypads are now erased.
3. Reprogram any remote control / keypad you would like to use.
Perform the following maintenance tasks monthly to ensure garage
door opener operates smoothly.
- Test the safety beam sensor and safety reversal system monthly,
refer to page 24.
- Open and close door manually to ensure door operates properly.
- Check door balance, if door is unbalance, contact a trained door
system technician.
- If chain / belt sags excessive below the rail, tighten the tension of
the chain / belt. Open the door until the trolley is about mid travel,
then stop. Disconnect the trolley then close the door manually.
Adjust the tension of the chain / belt
(refer to page 10). After
adjusting the tension, manually open the door until the trolley
connects to the turnbuckle.
- Lubricate door hardware such as rollers and hinges with light weight
general purpose grease when needed.
Erase Remote Control / Keypad from Memory
31
OPERATION
MAINTENANCE
