1.
Read and follow all installation instructions.
2. Check with the door manufacturer to determine if additional
reinforcement is required to support the door prior to
installation of the garage door opener.
3. Install garage door opener only on a proper balanced garage
door. An improperly balanced door could cause serious injury.
Have a qualified service professional make repairs to garage
door cables, spring assemblies and other hardware before
installing the opener.
4. Remove all ropes and disable all locks connected to the
garage door before installing opener.
5. Mount the emergency release handle 6’ (1.8m) above floor.
6. Do not connect the opener to source of power until this
manual instructs you to do so.
7. Locate the door control:
a. Within sight of the garage door.
b. Out of reach of children at minimum height of 5’ (1.5 m).
c. Away from all moving parts of the door.
8. Place entrapment warning label on wall next to garage
door wall control.
9. Install the Emergency Release Handle on the emergency
release rope.
10. Place manual release/safety reverse test label in plain view
on inside of garage door.
11. Upon completion of the installation, the door must reverse
when it comes in contact with a 11/2” (3.8 cm) high object on
the floor (or a 2x4 laid flat at the centre of the door) and when
the infrared safety beam is blocked.
n overall view of a completed garage door opener system
installed on a sectional door. The arrangement is similar
for a one-piece jamb door (except for differences
described later in this manual).
A
To reduce the risk of severe injury or death:
6
IMPORTANT INSTRUCTIONS
